HSN code 7218 — STAINLESS STEEL IN INGOTS OR OTHER PRIMARY FORMS
HSN · heading18%STAINLESS STEEL IN INGOTS OR OTHER PRIMARY FORMS; SEMI-FINISHED PRODUCTS OF STAINLESS STEEL
Stainless steel in its raw or semi-finished forms, including ingots, billets, slabs, and other primary shapes before final manufacturing into products. This code covers steel that has not been worked into finished goods like sheets, rods, or wires.
current gst rate
| igst | cgst | sgst | condition |
|---|---|---|---|
| 18% | 9% | 9% | Sch II S.No 271 |
source: 9/2025-Central Tax (Rate) · effective 2025-09-22 · all codes at 18%
gst calculator — pre-filled with this rate
products commonly classified here
semi-finished stainless steelSS billetsSS ingotsstainless steel billetsstainless steel bloomsstainless steel ingotsstainless steel primary formsstainless steel slabs
more specific codes
sibling codes
- 7201PIG IRON AND SPIEGELEISEN IN PIGS, BLOCKS OR OTHER PRIMARY FORMS
- 7202FERRO-ALLOYS
- 7203FERROUS PRODUCTS OBTAINED BY DIRECT REDUCTION OF IRON ORE AND OTHER SPONGY FERROUS PRODUCTS, IN
- 7204FERROUS WASTE AND SCRAP; REMELTING SCRAP INGOTS OF IRON OR STEEL
- 7205GRANULES AND POWDERS, OF PIG IRON, SPIEGELEISEN, IRON OR STEEL
- 7206IRON AND NON-ALLOY STEEL IN INGOTS OR OTHER PRIMARY FORMS (EXCLUDING IRON OF HEADING 7203)
- 7207SEMI-FINISHED PRODUCTS OF IRON OR NON-ALLOY STEEL
- 7208FLAT-ROLLED PRODUCTS OF IRON OR NON-ALLOY STEEL, OF A WIDTH OF 600 MM OR MORE, HOT-ROLLED, NOT
- 7209FLAT-ROLLED PRODUCTS OF IRON OR NON-ALLOY STEEL, OF A WIDTH OF 600 MM OR MORE, COLD- ROLLED (CO
- 7210FLAT-ROLLED PRODUCTS OF IRON OR NON-ALLOY STEEL, OF A WIDTH OF 600 MM OR MORE, CLAD, PLATED OR
- 7211FLAT-ROLLED PRODUCTS OF IRON OR NON-ALLOY STEEL, OF A WIDTH OF LESS THAN 600 MM, NOT CLAD, PLAT
- 7212FLAT-ROLLED PRODUCTS OF IRON OR NON-ALLOY STEEL, OF A WIDTH OF LESS THAN 600 MM, CLAD, PLATED O
Not sure this is the right code? Try the guided finder →
compiled from official sources · not tax advice · verify with your tax advisor before filing