HSN code 7201 — PIG IRON AND SPIEGELEISEN IN PIGS, BLOCKS OR OTHER PRIMARY F
HSN · heading18%हिंदी में देखें · தமிழில் பார்க்க
PIG IRON AND SPIEGELEISEN IN PIGS, BLOCKS OR OTHER PRIMARY FORMS
Pig iron and spiegeleisen (high-manganese iron) in their raw cast form as pigs, blocks, or other unrefined primary shapes. These are intermediate iron products used mainly for steelmaking and casting industries.
current gst rate
| igst | cgst | sgst | condition |
|---|---|---|---|
| 18% | 9% | 9% | Sch II S.No 260 |
source: 9/2025-Central Tax (Rate) · effective 2025-09-22 · all codes at 18%
gst calculator — pre-filled with this rate
products commonly classified here
primary iron formscast iron pigspig ironspiegeleisenपिग आयरनस्पीगेलेज़न
more specific codes
sibling codes
- 7202FERRO-ALLOYS
- 7203FERROUS PRODUCTS OBTAINED BY DIRECT REDUCTION OF IRON ORE AND OTHER SPONGY FERROUS PRODUCTS, IN
- 7204FERROUS WASTE AND SCRAP; REMELTING SCRAP INGOTS OF IRON OR STEEL
- 7205GRANULES AND POWDERS, OF PIG IRON, SPIEGELEISEN, IRON OR STEEL
- 7206IRON AND NON-ALLOY STEEL IN INGOTS OR OTHER PRIMARY FORMS (EXCLUDING IRON OF HEADING 7203)
- 7207SEMI-FINISHED PRODUCTS OF IRON OR NON-ALLOY STEEL
- 7208FLAT-ROLLED PRODUCTS OF IRON OR NON-ALLOY STEEL, OF A WIDTH OF 600 MM OR MORE, HOT-ROLLED, NOT
- 7209FLAT-ROLLED PRODUCTS OF IRON OR NON-ALLOY STEEL, OF A WIDTH OF 600 MM OR MORE, COLD- ROLLED (CO
- 7210FLAT-ROLLED PRODUCTS OF IRON OR NON-ALLOY STEEL, OF A WIDTH OF 600 MM OR MORE, CLAD, PLATED OR
- 7211FLAT-ROLLED PRODUCTS OF IRON OR NON-ALLOY STEEL, OF A WIDTH OF LESS THAN 600 MM, NOT CLAD, PLAT
- 7212FLAT-ROLLED PRODUCTS OF IRON OR NON-ALLOY STEEL, OF A WIDTH OF LESS THAN 600 MM, CLAD, PLATED O
- 7213BARS AND RODS, HOT-ROLLED, IN IRREGULARLY WOUND COILS, OF IRON OR NON-ALLOY STEEL
Not sure this is the right code? Try the guided finder →
compiled from official sources · not tax advice · verify with your tax advisor before filing